More suggestions, resin retention and plate removal

Resin Retention The shape of these models retains a significant amount of resin, wasting it. I would recommend cone shaped bottoms that slope down to drain slits on the sides, the tip of the cone being shorter than the bottom of the hex border so it never touches the table. Plate removal This design causes significant suction, making removal from the plate after printing difficult and causing model breaks and chips. This would be helped by the slits mentioned above, but you could also add some pads on external edges to allow the scraper to get a purchase before touching the model. From my previous suggestions, the orientation marker would also assist in making sure the magnets were placed with the correct polarization. If what I'm saying isn't clear, you can contact me at warren.tech@gmail.com My first prints look very good, minus the blemishes from the plate removal.